The Identity service supports the use of TLS to encrypt LDAP traffic. Before configuring this, you must first verify where your certificate authority file is located. For more information, see . Once you verify the location of your certificate authority file: Open the /etc/keystone/keystone.conf configuration file. Find the [ldap] section. In the [ldap] section, set the use_tls configuration key to True. Doing so will enable TLS. Configure the Identity service to use your certificate authorities file. To do so, set the tls_cacertfile configuration key in the ldap section to the certificate authorities file's path. You can also set the tls_cacertdir (also in the ldap section) to the directory where all certificate authorities files are kept. If both tls_cacertfile and tls_cacertdir are set, then the latter will be ignored. Specify what client certificate checks to perform on incoming TLS sessions from the LDAP server. To do so, set the tls_req_cert configuration key in the [ldap] section to demand, allow, or never: demand: a certificate will always be requested from the LDAP server. The session will be terminated if no certificate is provided, or if the certificate provided cannot be verified against the existing certificate authorities file. allow: a certificate will always be requested from the LDAP server. The session will proceed as normal even if a certificate is not provided. If a certificate is provided but it cannot be verified against the existing certificate authorities file, the certificate will be ignored and the session will proceed as normal. never: a certificate will never be requested. On distributions that include openstack-config, you can configure TLS encryption on LDAP traffic by running the following commands instead: # openstack --config --set /etc/keystone/keystone.conf \ ldap use_tls True # openstack-config --set /etc/keystone/keystone.conf \ ldap tls_cacertfile CA_FILE # openstack-config --set /etc/keystone/keystone.conf \ ldap tls_req_cert CERT_BEHAVIOR Where: CA_FILE is the absolute path to the certificate authorities file that should be used to encrypt LDAP traffic. CERT_BEHAVIOR: specifies what client certificate checks to perform on an incoming TLS session from the LDAP server (demand, allow, or never).