devstack/extras.d/README.md
Deepak C Shetty 93e2499ee1 doc: document override_defaults phase
override_defaults phase was added to devstack in [1]
but documentation was pending. This patch adds the
same. For history around override_defaults, one can
refer to the mail thread [2]

Also fixes a small typo

[1]: https://review.openstack.org/#/c/167933/
[2]: http://lists.openstack.org/pipermail/openstack-dev/2015-March/059621.html

Change-Id: I1b58ca0ce0e4b85a1dbd710b4c426606fd4dcf45
2015-11-18 12:43:54 +05:30

49 lines
2.1 KiB
Markdown

# Extras Hooks
The `extras.d` directory contains project dispatch scripts that are called
at specific times by `stack.sh`, `unstack.sh` and `clean.sh`. These hooks are
used to install, configure and start additional projects during a DevStack run
without any modifications to the base DevStack scripts.
When `stack.sh` reaches one of the hook points it sources the scripts in `extras.d`
that end with `.sh`. To control the order that the scripts are sourced their
names start with a two digit sequence number. DevStack reserves the sequence
numbers 00 through 09 and 90 through 99 for its own use.
The scripts are sourced at the beginning of each script that calls them. The
entire `stack.sh` variable space is available. The scripts are
sourced with one or more arguments, the first of which defines the hook phase:
override_defaults | source | stack | unstack | clean
override_defaults: always called first in any of the scripts, used to
override defaults (if need be) that are otherwise set in lib/* scripts
source: called by stack.sh. Used to set the initial defaults in a lib/*
script or similar
stack: called by stack.sh. There are four possible values for
the second arg to distinguish the phase stack.sh is in:
arg 2: pre-install | install | post-config | extra
unstack: called by unstack.sh
clean: called by clean.sh. Remember, clean.sh also calls unstack.sh
so that work need not be repeated.
The `stack` phase sub-phases are called from `stack.sh` in the following places:
pre-install - After all system prerequisites have been installed but before any
DevStack-specific services are installed (including database and rpc).
install - After all OpenStack services have been installed and configured
but before any OpenStack services have been started. Changes to OpenStack
service configurations should be done here.
post-config - After OpenStack services have been initialized but still before
they have been started. (This is probably mis-named, think of it as post-init.)
extra - After everything is started.